Serving Manteca, CA · San Joaquin County

Whole-Home Surge Protection in Manteca, CA

One surge — from the grid, a nearby strike, or your own big motors — can wipe out your electronics, EV charger, heat pump and smart panel. A whole-home surge protective device (SPD) at the panel is now NEC 230.67 code on service upgrades, and cheap insurance for an electrified home.

  • Panel-mounted SPD (Type 1 or Type 2)
  • Required by NEC 230.67 on new/upgraded services
  • Protects EV charger, heat pump, solar & electronics
  • Layered with point-of-use protection
  • Installed and tested by a licensed C-10

Licensed C-10 · CSLB #1114918 · Permitted & inspected

Free surge protection quote in Manteca

No obligation. Licensed C-10. Usually a reply within hours.

Pick your free visit time

Loading available times… (or we'll call to schedule)

By submitting you agree to be contacted about your request. No spam.

Certified installer & trusted partners

Tesla Certified InstallerSPAN Certified InstallerChargePoint InstallerAutel InstallerButterflyMX Certified InstallerGenerac Authorized DealerQmerit / AMP InstallerBright Saver Referral Partner

Whole-Home Surge Protection in Manteca — done right

Every job in Manteca starts with a free assessment and your home's Electrical Score, is sized by a real NEC load calculation, and is permitted and inspected in San Joaquin County. No guesswork, no cutting corners.

Panel-mounted SPD (Type 1 or Type 2)

Required by NEC 230.67 on new/upgraded services

Protects EV charger, heat pump, solar & electronics

Layered with point-of-use protection

Installed and tested by a licensed C-10

What does surge protection cost in Manteca?

Full cost guide →

A whole-home SPD installed on its own in our area typically runs $350–$650 — a fraction of what one surge can destroy.

Whole-home SPD (Type 2) installed at the panel$300 – $700
Type 1 SPD or panel needs space/breaker work$500 – $1,000
Added during a panel upgrade or EV/solar joboften a small add

Typical range for the San Joaquin County area, not a quote — your exact price comes from a free assessment.

Permits & your utility in Manteca

In Manteca, electric service is Pacific Gas & Electric (PG&E), and building permits are issued by City of Manteca. We pull the permit on every surge protection, coordinate the service and meter to PG&E's Electric & Gas Service Requirements (Greenbook, TD-7001M), and pass inspection — so it's safe, legal, and protects your home's value.

Manteca note: SSJID has a court-validated effort to take over PG&E electric here — re-verify periodically.

Not sure what your Manteca home needs?

Start with your home's Electrical Score — a licensed C-10 electrician grades your panel, service and wiring 0–100 for safety and capacity. Know before you buy an EV, add solar, or sell.

surge protection in Manteca — FAQ

Do I really need whole-home surge protection in Manteca?+

If you've added — or plan to add — an EV charger, heat pump, solar, or a smart panel, yes. Those are exactly the loads a surge destroys, and NEC 230.67 now requires an SPD on new and upgraded services. It's a small add that protects thousands in equipment.

Isn't a power strip enough?+

No. A plug-in strip only protects what's plugged into it, and not from the biggest surges coming in on your service. A panel-mounted SPD clamps the surge at the source, protecting your whole home — hardwired loads included. We often layer both.

Whole-Home Surge Protection in Manteca?

Book your free assessment with a licensed C-10 electrician today.

CallTextFree assessment
Surge protection in Manteca, CA | Astral